Band-it C00169 banding Instrukcja Użytkownika Pobierz pdf (Strona 2)

6. Place band in open slot of tool nose and gripper

block. Move into slot as far as possible to prevent

buckle from sliding into tool nose. With thumb on

band gripper lever, apply tension by turning handle

of tool. After tension is created, it is no longer

necessary to hold the band gripper lever as it

locks itself under tension. When band stops

moving through buckle, maximum tension has

been applied. Stop turning handle.

7. To set the lock and cut off band, roll tool nose

over buckle, relieving a slight amount of tension

by backing off tension handle during this fold

over operation. Failure to back off tension handle

throughout the entire course of roll over may

esult in br

eaking band. On the other hand,

releasing too much tension may result in a

loose clamp.

8. Pull cutting handle to cut the band.

9. Remove tool, holding stub of band down

with thumb.

10.

Hold clamp tail down between ears while

hammering the buckle ears down to hold

band stub in place. This completes the

secure BAND-IT clamp.

Fluted Pole Applications

When tensioning a

conventional clamp

over a fluted pole,

it is necessary to

extend the length

of the “lip wrap”

several inches to

assure contact with

2 or 3 flute ridges. Also, buckle placement over a

ridge is impor

tant to pr

ovide suppor

t for the lock

and prevent the “lip wrap” from shifting.

Forming a band clamp and

operating the Cool Tool

1 2

Forming a band clamp and 2

Komentarze do niniejszej Instrukcji

Brak uwag

Band-it C00169 banding Instrukcja Użytkownika Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Narzędzia Band-it C00169 banding